Reproduction of the original components required to rebuild the front end for Chevrolet Bel.

Sep 01,, Chevrolet Control Arm Bushing Removal Video. For use only with stumpdelimbing.bar © Timothy Daleo All rights reserved. Dec 20, Put a pipe end cap on one end of the nipple.

This is going to be your bushing driver. Lightly sand the bushing socket in the control arm to remove any rust buildup and file out any hard burrs. Spray the control arm socket area with some WD40 or liquid stumpdelimbing.barted Reading Time: 6 mins.

Remove the bushings from the shackle brackets on If you are replacing the springs then the front bushing will be already pressed into the front spring eye.

If you are just replacing the bushings then you will have to press the old bushing out of the front spring eye and press the new one in. for 55 Danchuk # and for Or File Size: 1MB. Raise front of the vehicle by using a 4 post lift or drive-on ramps. Securely block the rear wheels of the vehicle.

Do not remove the front wheels during installation for safety. It is imperative that the vehicle is at ride height for this installation.

Others have used an air chisel with success.

Installation of Hotchkis Front Sway Bar Sport Sway Bar Kit Chevy. Remove your factory centerlink and idler arm from your car as one unit. This would also be a good time to replace your worn tie-rod ends and pitman arm. Chevy Idler Arm Bearing Kit Instruction Sheet - #IBC Do the same with the centerlink as shown.

arms, remove the nut and washer that holds the bushings on the shafts upper and lower. To remove the bushings we used an air hammer with a chisel attachment. (You can also do this with a hammer and chisel by hand.) First, spray some lube on the outside of the bushings, it will make taking them out much easier.

Then, press the punch end or chisel. Part # Chevy Front Roller Bearing Conversion Kit Instruction Sheet. Part # Chevy Paint Divider Kit Instruction Sheet. Part # Clutch Cross Shaft Bushing Kit. Part # Chevy Outside Door Handle Assembly, Push Buttons Only Instruction Sheet.

Filter results by your vehicle.

Dec 20, How do you remove the front upper/lower control arm bushings from a 55 chevy - Answered by a verified Chevy Mechanic We use cookies to give you the best possible experience on our website. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them.

Username Post: bushing removal quinchem Forum Newbie Posts AM - Post# Hi all, I'm starting to rebuild the front end on my 55 wagon. I'm doing the upper and lower bushings on the"a-arms"(if that's what they're called on these??).