To replace the bushings in our factory track bar, we ordered Energy Suspension part 2.

Apr 18, Burn it out. Light the bastard on fire, let it simmer until the bushing and sleeve separate and the bushing element is stumpdelimbing.bar take about minutes. Then take a socket that fits the ID and knock out the outer bushing sleeve. Clean up the bore and install new bushing, good to stumpdelimbing.barted Reading Time: 4 mins. Adjustable bars will have a sleeve, so you don't have to remove the track bar ends.

You'll want the adjustable end at the axle side. As far as adjusting your new track bar is concerned, does one tire stick out of the wheel well/fender more than the other (usually driver’s side)? If you're unsure, measure the distance from the tub or suspension, something solid and equal on both sides to the outside edge of. Mar 26, Welcome back to OffTheJeepEnd!

In this video, we replace the track bar bushings in our Jeep YJ Cupid! There is a lot more to come for Cupid in time, but for. Oct 25, Removing the front track bar was the only way I could get my YJ to flex with a SUA setup. With a SUA setup running a total of 9" of lift I got the front tires (33s) to rub the fenders without the track bar.

However the downside to removing the track bar. Jan 03, The factory bushing does not come out of the factory track bar without putting up a fight. There are two methods for removing this bushing. First (and not very efficient) drill the rubber and turn it into Swiss stumpdelimbing.bars: Via CallejonSan Clemente, CA Aug 04, Video discussing the TJ's steering problems and showing the replacement of rear track bar stumpdelimbing.barimer: The information, demonstration a picture of fall trees any content.

Rubicon Express Front Track Bar Bushing Kit with 10mm Bolt.Synergy Manufacturing Dual Durometer Track Bar Bushing 9/16" 14mm.Prothane Rear Track Bar Bushing Kit for Jeep Wrangler JK.More choices available. Energy Suspension Front Track Bar Bushing Set for Jeep Wrangler TJ.5/5. The"Track Bar" is the 1" thick rod that holds your front axle from slipping out from under your Jeep or Bronco or Dodge Ram when you turn a corner.

On a coil-sprung vehicle, the track bar locates the axle a specific distance from the driver's side frame rail, and"steadys" the coil springs, keeping them from allowing the body of the Jeep to move independent (left and right) of the axle. Jeep Wrangler TJ track bars are simple devices that connect one end of the axel to the frame of the chassis on the other side of the vehicle.

The pivots of the track bar allow either end to swivel up and down, but not side to side.