Let me list out a few reasons why you should cut your tree.

TREE FELLING TECHNIQUES MANUAL. BACK CUT TOO DEEP (INADEQUATE HINGE) BACK CUT TOO HIGH ABOVE THE NOTCH. BACK CUT BELOW THE NOTCH.

SLOPING BACK CUT. ANGLE-BACK CUT WITH INADEQUATE NOTCH. Felling The Tree (Summarize) Mark Cut Locations With Surveyors' Paint (Visually Plan Felling Approach) Face The Tree (Two Planar Cuts) –Select A Face Cut Type: Open, Conventional, Humboldt –Always Located On The Desired Felling Direction Side Of The Tree –Check Face Location With A Horizontal Line Centered And.

Jul 19, I should have stated the obvious, I use a gunning cut, a Humboldt, and backcut 99% of the time. These three cuts go in fast and they work. Simple is best. The most common technique I add is to cut the stumpdelimbing.barted Reading Time: 6 mins. Hands-on techniques for felling trees. Basic Felling Techniques. Note: on this page, ‘front’ and ‘back’ are arbitrary terms, the front being the side towards which the tree is intended to Felling Larger Trees. Felling Small Trees. Problems.

Snedding. Make A V-Shaped Cut. For your tree to have a smooth fall, you will make a V-shaped notch on the side of the tree that’s facing the direction where you want it to fall.

Cut at about the knee-height of a regular-sized person. This V-shaped cut should reach the center of the tree, and the tips of the top and bottom cut must meet in the middle. Make A Back CutEstimated Reading Time: 7 mins. Mar 05, The open-faced notch is perfect for trees that require a high level of accuracy.

On the off chance that the individual is cutting in a tight spot, where accuracy is pertinent, the open-faced notch is considered the safest and secure notch to use.

In this notch, a vast, sideways V is cut into the side of the tree. Mar 25, Tree Felling wedges; An axe; Ask any professional about the best way how to cut a tree down and they will most likely tell you it starts with a good quality saw that has a sharp chain.

Husqvarna is a very popular brand for high quality chainsaws with. The sequence of the remaining cuts depends on the type of bind.

Generally the next cut will be a small, less than 11⁄ 2 inches, pie-shaped cut removed from the compression area. The log can settle slowly into this space, preventing dangerous slab-bing and splintering. This practice is extremely important when cutting large logs. The final cut, or release cut, will be made through the tension stumpdelimbing.bar Size: 1MB.

Aug 21, Tree cutting and felling in tight areas. Showing you our Ford f service body with gooseneck setup. Support the channel by subscribing, sharing and leaving your feedback in the comments 💯 Thanks for watching!

🌲 Business Contact: Kenny's Tree.